Denim

Your supply only. We don’t hold stock of any denim material. The fabrics gallery is to give an indication of how the laser reacts to different textiles. We recommend having your fabric sent straight to us from your supplier once a quotation is confirmed.

Thickness: Any thickness
Sheet sizes: Any size up to 3000×2000mm


See more on our laser cutting and engraving service for fashion and textile designers»

Material properties

Denim is a rugged cotton twill textile. As you probably know already, denim is traditionally coloured blue with indigo dye.


Laser cutting

Denim laser cuts cleanly. Marks on the top surface are not usually noticeable. We cut denim on the engraving table or clean honeycomb bed which can also mark the material underside very slightly.


Cut edge

The laser seals the edge to prevent fraying with a light brown appearance.


Cut widths & Kerf

As a benchmark, we recommend that minimum cut widths be no thinner than 2mm. We can go smaller (see cut width image above) but this can make your fabric quite fragile which might not be suitable for the application. See more on cut widths and Kerf (how much the laser takes away.)


Laser engraving

The engraving will be lighter in contrast to the denim colour ranging in shades of light brown to white (depending on the type.)


Supplying fabrics as flat as possible

You need to make sure you supply your denim as flat as possible. Try and make sure it is not crumpled, this can cause issues when cutting.